Pressure Gauges
Home
 
About Us
 
Products
 
Enquiry
 
Contact Us

  Products

  1 2 3

Diaphragm Sealed Gauges

The Diaphragm sealed gauges are recommended where fluid is highly corrosive, contaminated, and viscous or may crystallize inside measuring system. The gauge above the diaphragm seal is packed with appropriate oil that transmits the pressure acting on the diaphragm to bourdon tube diaphragm, which is welded to the upper part of sealed unit. This makes it easier to separate the upper and lower parts, in order to clean the diaphragm without removing the gauge. Diaphragm can be ANSI 316 of Tantalum, Hastelloy C and Monel. Pressure gauge can be of Type 1.3 and 5 and process connection with Standard threads or flanged connection confirming to ANSI, BS or DIN Specification. These are available in dial size 100 mm and 150mm. It has an accuracy of ± 1 % in all standard ranges.

Diaphragm Sealed Gauges

Compact Capsule Gauges
Compact Capsule Gauges

These gauges are meant for measuring low pressure or vacuum normally Air or Gas. These are available in dial size 63, 100 and 150 mm with a specification for mounting and connection with M. S. Case or cast aluminum weatherproof case. These have an accuracy of 63 mm± 3% and 100 and 150 mm ± 2%. These have Standard pressure range in mm WC, mBar and inches of water column and are available in Ranges from 25 mBar upto 400 mBar.


Test Gauges

Originally test gauges are used in laboratories for testing and inspection of other gauges as well as for high accuracy measurement. These have an accuracy of ± 0.5% and ± 0.6 in type 8 and ±0.25% of RS.D. Each test gauge is undergoes on Dead Weight Tester and Test Certificate of Calibration TRACEABLE TO NATIONAL STANDARDS confirming to ISO 9000 necessities. These are available in dial size 150 and 250 mm and are manufactured in all standard ranges in pressure or Vacuum in kg/cm2 and psi.

Test Gauges

Contact Gauges

Contact Gauges


Contact gauge works ideally where control of pressure and for audible or visible alarms is required. Contact gauges are provided with single, double or triple contacts which are amendable all over the range with various modes of switching action. It allows the alternative of low action normal contact, snap action magnetic contact or inductive contact; these are manufactured in Bottom / Back connection and Direct / Surface / Panel mounting. These are offered in dial size 100 mm and 150 mm and in all standard ranges.


Differential Pressure Gauges

The differential pressure gauge consists of 2 bourdon tubes, out of which one is meant for highland and the other for low pressure line. The pointer of the instrument provides direct reading off differential pressure. Each bourdon tube can acquire maximum pressure limit of 1.3 times the highest range shown on the dial. These gauges are manufactured in dial size 150 mm and with pressure range from 0-t kg/cm2 upto 1000 kg/cm2, in addition to an accuracy rate of ± 1%.

Differential Pressure Gauges

  1 2 3

       


eNabled by : NEW AGE